Текст страницы
2
Main board malfunctioned.
Replace the main board.
Fuser Error(201622)
The thermistor outside the Fuser is not connected.
< User Check >
(1) Turn off and then on the power.
(2) Turn off the power.
Step
Cause
Solution
1
Thermistor malfunctioned.
Replace the Fuser.
2
Main board malfunctioned.
Replace the main board.
Fuser Error(201623)
Fuser's side thermistor did not rise to the specified temperature within the specified time:
From normal temperature to Ready state, the side thermistor did not heat up from -20 degrees to 0 degrees
in 5.5 seconds.
< User Check >
(1) Turn off and then on the power.
(2) Replace the fuser.
Step
Cause
Solution
1
Thermistor malfunctioned.
Replace the Fuser.
2
Main board malfunctioned.
Replace the main board.
Not install drum unit (200041)
Please install the drum unit and then restart. (200041). No drum unit or printer can not detect drum unit.
< User Check >
(1) If there is drum unit installed in the printer.
(2) Check if the drum unit cable and that if the chip has been assembled in place.
Step
Cause
Solution
1
Drum cable was loose.
Reconnect the cable.
2
Drum cable connection port
deformed.
Replace the drum connection port.
IF98 FFC cable was loose.
Reconnect the cable.
IF98 FFC cable damaged.
Replace the IF98 FFC cable.
3
IF98 board malfunctioned.
Replace the IF98.
4
main board malfunctioned.
Replace the main board.
Drum unit lifetime end(200042)
Please replace drum unit (200042). The printer detected the drum unit lifetime end.
< User Check >
(1) Replace the drum unit.
Step
Cause
Solution
1
Drum unit lifetime end
Replace the drum unit.
Drum unit near end of life(200043)
Please replace drum unit (200043).
When the printer detects the lifetime is lower than 10%.
< User Check >
(1) Need to prepare a new drum unit.
Step
Cause
Solution
1
Drum unit near end of life
You can continue printing since the
printing quality will not be affected.
Confidential
18