Инструкция принтер лазерный Катюша P130


Fuser Error(201600)
The temperature of the heating lamp exceeds max. degrees (210 degrees).
< User Check >
(1) Turn off and on the printer.
(2) Turn off the power.

Step
Cause
Solution

1
Thermistor malfunctioned.
Replace the fuser.

2
Main board malfunctioned.
Replace the main board..

Fuser Error(201604)
ADC Calibration Not Ready
< User Check >
(1) Turn off and on the printer.
(2) Turn off the power.

Step
Cause
Solution

1
Main board malfunctioned.
Replace the main board..

Fuser Error(201605)
ADC Not Ready：The ADC-value query for Side and Center Lamp failed every 100ms.
< User Check >
(1) Turn off and on the printer.
(2) Turn off the power.

Step
Cause
Solution

1
Main board malfunctioned.
Replace the main board..

Fuser Error (201607)
Temperature difference between the center and the two sides of the lamp over 40 degrees.
< User Check >
(1) Turn off power and then turn on.
(2) Turn off the power.

Step
Cause
Solution
1
Operating temperature too low.
Change the operating temperature and
restart the printer.
2
Used voltage too low
Check power and avoid using
overloaded electrical appliances on the
same line.

Fuser Error(201613)
The temperature of the Center lamp is more than 20 degrees different from the last time.
< User Check >
(1) Turn off and then on the power.
(2) Turn off the power.

Step
Cause
Solution

1
main board malfunctioned
Replace the main board.组件

Fuser Error(201615)
The thermistor in the middle of the Fuser did not rise to the specified temperature within the specified time:
From normal temperature to Ready state, the center thermistor did not heat up from -20 degrees to 0
degrees within 5.5 seconds.
< User Check >

Confidential
16