Текст страницы
en
Fault
Cause and troubleshooting
E:30 -10 /
The tap is turned off.
▶Turn on the tap.
The water inlet hose is kinked or jammed.
▶Check the installation of the water inlet hose.
→ Page 14
The filters in the water inflow are blocked.
▶Clean the filters in the water inflow.
Scan the QR code to see an animation of the pro-
cess.
The water pressure is low.
▶Check whether the tap has sufficient water pres-
sure.
The water level measuring system is defective.
With this error message, the appliance starts a drain-
ing process.
1. Wait approx. 5 minutes until the draining process
ends.
2. Restart the appliance.
If required, start the draining process again.
3. If the fault persists, call customer service.
→ Page 44
E:30 -20
Critical malfunction.
▶Turn off the water tap.
With this error message, the appliance starts a drain-
ing process.
1. Wait approx. 5 minutes until the draining process
ends.
2. Restart the appliance.
If required, start the draining process again.
3. If the fault persists, call customer service.
→ Page 44
Detergent dosage is too high.
▶Reduce the amount of detergent for the next wash-
ing cycle with the same load.
Additional water has been added.
38