Текст страницы
en
Fault
Cause and troubleshooting
The laundry is too wet
after the spinning
cycle.
A low spin speed is selected.
▶Start the Spin
programme.
▶The next time you run a wash cycle, set a higher
spin speed.
The appliance is using a reduced spin speed to elim-
inate an imbalance.
1. Redistribute the laundry in the drum.
2. Start the Spin
programme.
Creasing.
The selected programme is unsuitable for the type of
fabric.
▶Set a suitable programme. → Page 22
A high spin speed is selected.
▶The next time you run a wash cycle, set a lower
spin speed.
The load is unsuitable.
▶Observe the programme's maximum load capacity.
→ Page 22
▶Prepare the laundry. → Page 26
Water is leaking out at
the water inlet hose.
The water inlet hose is not correctly connected or is
damaged.
▶Check the installation of the water inlet hose.
→ Page 11
Replace the water inlet hose if it is damaged.
Water is leaking out at
the water outlet hose.
The water outlet hose is not connected correctly or is
damaged.
▶Check the installation of the water outlet hose.
→ Page 11
Replace the water outlet hose if it is damaged.
Water is leaking from
below the door.
Dirt on the door or seal causes leaks.
▶Clean the door and the seal.
There is too much detergent or fabric softener in the
detergent drawer.
▶When dosing, observe the marking in the detergent
drawer. → Page 29
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Insert in compartment
is blocked.
▶Clean the detergent drawer. → Page 32
Residual water is
present in the com-
partment
.
41