Инструкция точка доступа TP-Link CPE605

4.1 Configure WAN Parameters

Note:

WAN submenu is only available in AP Router Mode and AP Client Router (WISP Client)
Mode.

WAN submenu is used to create the WAN connection and configure the related advanced

parameters.

Go to the Network page. In the WAN section, configure the WAN parameters of the device.

Follow the steps below to configure the WAN parameters:

1. Select the connection type according to your need. The device supports five types:

Static, Dynamic, PPPoE, L2TP, and PPTP.

Note:

L2TP or PPTP is only available on certain devices. To check whether your

device supports this feature, refer to the actual web interface.

■Static

This connection type uses a permanent, fixed (static) IP address that is assigned by your ISP. In

this type, you should fill in the IP address, Netmask, Gateway IP, and DNS IP address manually,

which are assigned by your ISP.

59