Инструкция точка доступа TP-Link CPE605

Go to the Network page. In the Management VLAN Interfaces section, enable the

Management VLAN function, specify VLAN ID and click Apply. Then click Save.

Enable or disable the Management VLAN function. By default, it is disabled.

Management
VLAN

VLAN ID
Specify the Management VLAN ID. The valid values are from 2 to 4094.

4.4 Configure the Forwarding Feature

Note:

Forwarding submenu is only available in AP Router Mode and AP Client Router (WISP
Client) Mode.

The IP address used on the internet is public IP address, while IP address used on local

area network is private IP address. The hosts using private IP addresses cannot access

the internet directly and vice versa.

The hosts using private IP addresses visit internet through NAT (Network Address

Translation) technology. NAT can transfer private IP addresses into public IP addresses to

realize the communication from internal hosts to external hosts.

If the hosts on the internet want to visit the hosts on local area network, the forwarding

function should be used, including DMZ, Virtual server, Port triggering and UPnP.

Go to the Network page. In the Forwarding section, configure the following parameters

and click Apply. Then click Save.

77