Текст страницы
2. Click Add and create the filtering entries.
Enable
Enable or disable the desired entry.
Protocol
Choose one of the protocols from the drop-down list used for the target,
any of IP, TCP, UDP, or ICMP.
Host IP
Enter the IP address or address range of the hosts that you need to
control, for example 192.168.0.12-192.168.0.25.
Target IP
Enter the IP address or address range of the targets that you need to
control, for example 192.168.3.12-192.168.3.25.
Target Port
Specify the port or port range for the target when protocol is TCP or
UDP.
Days of a week
Specify the days in which the rules take effect.
Time
Enter the time rule in HH:MM-HH:MM format, the default value is 00:00-
24:00.
3. Click Save and click Apply, then click Save.
4.7 Configure Static Routing
Note:
Static Routing submenu is only available in AP Router Mode and AP Client Router (WISP
Client) Mode.
A static route is a pre-determined path that network information must travel to reach a
specific host or network. If static route is used properly in the network, it can decrease the
network overhead and improve the speed of forwarding packets.
Static routing is generally suitable for simple network environment, in which users clearly
understand the topology of the network so as to set the routing information correctly.
When the network topology is complicated and users are not so familiar with the
topology structure, this function should be used with caution or under the guidance of the
experienced administrator.
85