Инструкция точка доступа TP-Link CPE605

1. Go to the Network page. In the Static Routing section, click Add and specify the

following parameters.

Enable
Enable or disable the desired entry.

Target Network
IP

Enter the Target Network IP, the address of the network or host to be
visited. The IP address cannot be on the same network segment with the
device’s WAN or LAN port.

Netmask
Specify the netmask for the desired entry.

Gateway IP
Enter the Gateway IP, the address of the gateway that allows for contact
between the Device and the network or host

2. Click Save and click Apply, then click Save.

4.8 Configure Bandwidth Control

Note:

Bandwidth Control submenu is only available in AP Router Mode and AP Client Router
(WISP Client) Mode.

Bandwidth control function is used to control the internet bandwidth in the local area

network. In the case of insufficient bandwidth resources, enable the function to make the

device allocate reasonable bandwidth to the clients and achieve the purpose of efficient

use of the existing bandwidth. Via IP bandwidth control function, set the upper and lower

limit in the bandwidth of the computer network and guarantee a smooth sharing network.

86