Инструкция точка доступа TP-Link CPE605

IPv6
Enable or disable the IPv6 function. If the IPv6 function is enabled, the
device will obtain a WAN IPv6 address. Select a method for the device to
obtain the WAN IPv6 address according to the information provided by
your ISP.

• Static

Select static and enter the WAN IPv6 address, IPv6 netmask, IPv6
gateway, primary DNS and secondary DNS provided by your ISP.

• SLAAC

Select SLAAC and the device will obtain the WAN IPv6 address
automatically.

• DHCPv6

Select DHCPv6 and the device will obtain the WAN IPv6 address
automatically.

MTU Size
Specify the MTU size. The normal MTU (Maximum Transmission Unit)
value for most Ethernet networks is 1500 Bytes. For some ISPs you need
to modify the MTU. But this is rarely required, and should not be done
unless you are sure it is necessary for your ISP connection. This number
should be an integer between 576 and 2026.

Use These DNS
Servers

If your ISP gives you one or two DNS IP addresses, select Use These
DNS Servers and enter the Primary DNS and Secondary DNS into the
correct fields. Otherwise, the DNS servers will be assigned from ISP
dynamically.

Primary DNS
Enter the DNS IP address provided by your ISP.

Secondary DNS
Enter another DNS IP address provided by your ISP.

62