Текст страницы
26 | English
Anti-clockwise rotation: To loosen or unscrew screws, slide the rotational direction
switch (5) backwards.
Switching On and Off
There are 2 ways to switch on the power tool.
– Exert pressure on the spindle and maintain this pressure to continue using the power
tool. To switch it off, stop exerting pressure on the spindle.
– Press the On/Off switch (4). To switch off, release the on/off switch (4).
Using as a manual screwdriver (see figure C)
To use the power tool as a manual screwdriver, slide the rotational direction switch (5)
to the middle position.
This enables screws to be screwed in even when the battery is empty and allows the
power tool to be used as a screwdriver.
Preselecting the torque
The torque presetting ring (3) can be used to pre-select the required torque in 7 stages.
Once the pre-selected torque has been reached, the tool will stop delivering power to the
application.
Stage 1:
Lower torque for driving in screws with a small diameter or for use with soft materials.
Stage 7:
Higher torque for driving in screws with a large diameter or for use with hard materials.
Temperature-dependent overload protection
In normal conditions of use, the power tool cannot be overloaded. If the power tool is
overloaded or the permitted battery temperature is exceeded, the electronics of the
power tool will switch off until the temperature returns to within the optimum operating
temperature range.
Protection against deep discharge
The lithium-ion battery is protected against deep discharge by the "Electronic Cell Pro-
tection (ECP)". When the battery is discharged, the power tool is switched off by means
of a protective circuit: The application tool no longer rotates.
1 609 92A 7HS | (08.09.2023)
Bosch Power Tools