Инструкция роутер Tenda 4G08

When the failover function is enabled, the page is shown as below. You can configure the failover
connection by referring to Access the internet through the WAN port.

5.3.2 Example of setting up failover connection

Scenario: You used to insert a SIM card in the router to access the internet, but you install a smart
home gateway after subscribing to the broadband service recently.

Requirement: Set the router to access the internet through the broadband, and use the SIM card
as backup in case of broadband failure.

Solution: Connect the broadband to the router and insert the SIM card into the router, and
configure the failover function.

Assume that the ISP provides a PPPoE user name and PPPoE password for setting up internet
connection.

Procedure:

1. Connect the WAN/LAN port of the router to the LAN port of your smart home gateway.

2. Log in to the web UI of the router.

3. Navigate to Internet Settings.

4. Enable the Failover function.

5. Set Connection Type to PPPoE, and enter the PPPoE Username and PPPoE Password provided

by your ISP.

6. Set DNS Settings and VLAN ID as required.

7. Click Connect.

40

Document Version: V1.0