Текст страницы
Parameter description
Parameter
Description
Specify the mode of signal strength. The default mode is High.
2.4 GHz Network
−
High: It is typically used to meet wireless coverage requirements in large or multi-
barrier environments.
−
Medium: It is typically used to meet wireless coverage requirements in medium-area or
less-obstacle environments.
5 GHz Network
−
Low: It is typically used to meet wireless coverage requirements in small area or barrier-
free environments.
6.5 WPS
6.5.1 Overview
The WPS function enables wireless devices, such as smartphones, to quickly and easily connect to
Wi-Fi network of the router without entering the Wi-Fi password. There are two ways to connect
devices to the Wi-Fi network.
−
Connect devices to the Wi-Fi network using the WPS button
−
Connect devices to the Wi-Fi network through the web UI of the router
To enable or disable the WPS function, log in to the web UI of the router, and navigate to Wi-Fi
Settings > WPS.
−
This function is only applicable to WPS-enabled wireless devices.
−
If the WPS function is disabled, the internet cannot be connected through the WPS function of the
router.
6.5.2 Connect devices to the Wi-Fi network using the WPS
button
1. Find the MESH/RST button on the rear panel of the router, and hold it down for about 1
second. The Wi-Fi indicator blinks.
2. Configure the WPS function on your wireless devices within 2 minutes. Configurations on
various devices may differ (Example: HUAWEI P10).
52
Document Version: V1.0