Текст страницы
Security
●To specify an IPv4 or IPv6 address to which IPSec is applied, select [IPv4 Manual Settings] or [IPv6 Manual
Settings].
[Addresses to Set Manually]
When [IPv4 Manual Settings] or [IPv6 Manual Settings] is selected, enter the IP address. You can also
specify a range of IP addresses by using a hyphen (-).
Input example:
●One IPv4 address
192.168.0.10
●One IPv6 address
fe80::10
●Range specification
192.168.0.10-192.168.0.20
[Subnet Settings]
When [IPv4 Manual Settings] is selected, you can use a subnet mask to specify the range of IPv4
addresses.
Input example:
255.255.255.240
[Prefix Length]
When [IPv6 Manual Settings] is selected, you can use a prefix length to specify the range of IPv6
addresses. Enter the prefix length with a range of 0 to 128.
[Port Settings]
Set the port to which IPSec is applied in [Local Port] on the machine and [Remote Port] on the
communicating device.
●To apply IPSec to all port numbers, select [All Ports].
●To apply IPSec to a specific protocol such as HTTP or WSD, select [Single Port], and enter the port number
of the protocol.
8 In [IKE Settings], set IKE.
[IKE Mode]
The machine only supports the main mode.
[Authentication Method]
Select the authentication method of the machine.
●When [Pre-Shared Key Method] is selected, click [Shared Key Settings]
enter the string to use as the
shared key using single-byte alphanumeric characters
click [OK].
●When [Digital Signature Method] is selected, click [Key and Certificate]
[Register Default Key] to the right
of the key and certificate to use.
[Validity]
Enter the valid period of IKE SA (ISAKMP SA) to use as the control communication path in minutes.
[Authentication/Encryption Algorithm]
Select the algorithm to use for key exchange.
9 In [IPSec Network Settings], configure the IPSec network settings.
[Use PFS]
Select this checkbox to configure PFS for the session key.
[Validity]
220