Текст страницы
Settings Menu Items
[Waiting Time for Connection at Startup]
[Menu]
[Preferences]
[Network]
Set the waiting time until a connection is established when the machine starts up.
If the machine is connected via a device such as a switching hub, you may not be able to connect to the network even
when the setting on the machine is correct. If so, set the waiting time and reconnect.
0 to 300 (sec.)
[Ethernet Driver Settings]
[Menu]
[Preferences]
[Network]
Set the Ethernet communication method.
Manually Configuring the Ethernet Settings(P. 60)
This also allows you to check the MAC address on a wired LAN.
Viewing the MAC Address of the Wired LAN(P. 74)
* If the [Communication Mode] is set to [Half Duplex], [1000BASE-T] cannot be selected.
[Auto Detect]
[Off]
[Communication Mode]
[Half Duplex]
[Full Duplex]
[Ethernet Type]
[10BASE-T]
[100BASE-TX]
[1000BASE-T]
[On]
[MAC Address]
[IEEE 802.1X Settings]
[Menu]
[Preferences]
[Network]
Specify whether to use IEEE 802.1X.
Use Remote UI from a computer to set the IEEE 802.1X authentication method.
Using IEEE 802.1X(P. 222)
* [IEEE 802.1X Settings] may not be displayed depending on the model, and other settings.
[Off]
[On]
[Firewall Settings]
[Menu]
[Preferences]
[Network]
Specify whether to enable an IP address filter and MAC address filter.
Use Remote UI from a computer to set the default policy for filtering and the exception addresses.
Setting the
Firewall(P. 210)
[IPv4 Address Filter]
301